Drl installation

This is the ACC spot. Basically, when the engine is on, the indicator lights up. When the engine is off, the indicator is also off. Once you find the ACC location, you can tap the red wires to the blade of the fuse and insert it back.

Installation is not at all complicated, but actually quite effortless. Here are a few more photos of the LEDs. These instructions do not follow the key legislation around DRL which is that they must turn off when other lights are turned on.

At night these lights would be far too bright. The wire connection directly to the ACC fuse is both unsafe and unprofessional. Also, your description doesn't ensure you are connected to the back side of the fuse, anyway.

The proper connection would be a quick-tap splice to the back-side wire of the ACC fuse with a separate in-line fuse for the DRL. That way, if the DRL overloads the fuse, only the in-line fuse will be blown and the rest of the ACCessories will still have power. Question 3 years ago on Step 9. If your DRL harness did not comes with any yellow wire , just leave the connection on the headlight unplug. For DRL harness that comes with a yellow wire , connect that to the nearest headlight, you will only need to connect to one headlight and leave the yellow connector on the other headlight unplug.

Basically, the DRL harness will supply extra power to the DRL for brighter output during daytime, and when the parking light is on, the DRL will be at reduced intensity. With the optional harness installed, the headlights will function as follows with most vehicles:.

With the grey wire, you will need to tap it into a switched fuse under the hood. Steps 7. Time Required 1 hour. Sections 1. Flags 1. Member-Contributed Guide An awesome member of our community made this guide. Introduction LED daytime running lights are a great add-on to any vehicle to increase light output for style and safety.

Add a comment. Add Comment Cancel. Step 2. Step 3. Transfer turn signal bulb and socket to new headlights. For model with Sequential turn signal , please refer to the following additional steps -Remove both side marker and turn single socket -Remove all sticker that covering the headlight opening -Insert the 2 wire pin into the side marker socket ,re-install the socket back onto the headlight -Install turn signal socket onto headlight , plug the grey color plug onto the socket , located the black plug and connect that to the turn signal wire from the truck.

Step 6 Plug in all connections including the DRL wire if you are installing the optional harness. Step 7 If you are planning to install the optional DRL harness, connect the red wire from the DRL harness short end to driver side, long end to passenger side For more information about wiring the DRL harness, please read our article about How to wire the DRL harness?

Step 8 You will next aim the headlights at about 25ft against a wall on a level surface. You are all set! Tags: toyota tundra , toyota sequoia , toyota tundra , toyota sequoia , toyota tundra , toyota sequoia , toyota tundra , toyota sequoia , toyota tundra , toyota sequoia , toyota tundra , toyota sequoia , toyota tundra , toyota sequoia , toyota sequoia , toyota sequoia , toyota sequoia , installation guide.